Loading
Loading
Hard-facing, wear-plate replacement and component rebuilds that extend equipment life and reduce downtime.
From buckets and ground-engaging tools to crusher liners and chute plates, we rebuild and protect the parts that take the most punishment.
We extend the service life of your buckets, GETs, crusher liners and chute plates with materials and weld procedures matched to your operating conditions.
Bucket wear plate replacement and hard-facing
GET, tooth and adapter rebuilds for ground-engaging tools
Crusher liner, jaw plate and chute liner fabrication
Hard-facing wire and rod application matched to material
Boom and arm reinforcement for heavy load applications
Wear monitoring and condition-based replacement scheduling
Material selection consultancy for new and replacement parts
Onsite delivery or workshop turnaround across NSW and QLD
Hard-facing application matched to your operating conditions, wear plate replacement and full bucket rebuilds. We help you get more service life out of every wear part.
We rebuild buckets from the inside out, wear plates, cutting edges, GETs and structural repairs. Then we add hard-facing where it matters most for your operation.
Small wear jobs on site, larger rebuilds in our workshop. Either way, your equipment comes back to spec with documented service records.
Wear plate replacement, hard-facing and full GET refresh.
OEM and aftermarket tooth, adapter and shroud installation.
Custom-fabricated jaw plates, side liners and chute liners.
Wear plate addition to high-stress areas of booms and arms.
Application matched to material, abrasion, impact or both.
Condition-based replacement scheduling for fleet operators.
We inspect the job, confirm scope and provide transparent pricing, no surprises mid-project.
Mobile workshops, crews and equipment arrive ready to work. Compliance, induction and isolation handled upfront.
Full inspection, service and parts records handed over for your audit, tender and compliance documentation.
Every wear job is matched to your operating conditions, with material selection and weld procedures that genuinely outlast the original spec.
Yes, OEM and aftermarket buckets, teeth, adapters and shrouds across all major brands.
Yes, onsite hard-facing application using mobile welding rigs, with material selection matched to your operating conditions.
Depends on the operating conditions, but properly applied hard-facing typically adds 50-200% to GET and bucket service life.
Yes, we supply OEM and aftermarket wear parts and can quote on full replacement vs hard-facing repair, whichever makes more economic sense for your job.
From our Wetherill Park (Sydney) and Gold Coast bases we cover the East Coast, including Brisbane, Newcastle, Wollongong and broader NSW/QLD project sites.
See full service areas
Mobile hard-facing teams across Sydney, the Gold Coast and East Coast project sites, onsite or in workshop.